2007 Shelby GT500 – TVS Supercharger and Gauge Install – Completed
It’s been awhile since our last blog so we thought it was time to update you with another cool project. The last couple days we’ve been installing a TVS 2300 supercharger and Aeroforce Gauges on a racing 2007 GT500. You might recognize this car from a previous blog when we installed a racing roll bar. Now it was time for some more power! The car already has a Steeda CAI, pulley, JBA axle back and a custom tune from another shop. It put down a conservative 487rwhp. To start off the project as always everything has to come apart. We started off by removing the intake and fuel rails. With that out of the way we could then loosen the belt for the supercharger. With that out of the way we could start unbolting the stock blower and carefully removing it out of the car. With the old blower out we can already see the difference between the two blowers. Now to put on this bad boy. With the blower in place the fuel system, belt and intake could go back on. With that out of the way. It was time to move onto the gauges. We started off by removing the factory pillar and started to run some of the wiring for the new Aeroforce Gauges. With the wiring ran the new pillar pod could be installed and the gauges mounted. After some dialing it they were ready to go. Now it was time for the dyno. After some tuning this bad boy made 608rwhp and 630rwtq! That’s a 121rwhp increase with only 4lb pounds of boost with the much more efficient TVS. Now this thing is ready to get back on the track. Check back soon for more installs by RPMM!
