2008 Mustang Bullitt-Whipple Supercharger and Gauges Install-Part IV

Well we got a lot of work done on the Bullitt. As you can see the front bumper has to come off for the heat exchanger. After that was installed we installed the new GT500 fuel pumps and wiring and driver. The remaining wiring is pulled through the fender for the gauges and ran to the engine compartment. Soon we will have this running so check back soon for the start up video!

Advertisements

~ by renegademustangs on April 22, 2010.

One Response to “2008 Mustang Bullitt-Whipple Supercharger and Gauges Install-Part IV”

  1. looks good fella’s keep up the good work and hopfully I will make the next paygrade then you will have another Whipple to install!!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

 
%d bloggers like this: